The AMP300 is an excellent power
amplifier for pro-installation application. It is High Current (2 Ohm Stable)
two channel power amplifier and overload stable. It is idea for use as a remote
amplifier, single or dual zone amplifier. It is perfect heavy duty high fidelity
amp for powering your whole house audio system. It weights 40lbs and can produce
serious high current to drive your whole house audio speakers.
Feature
• 150 watts RMS per channel power
amplifier with complete custom installer feature set
• Bridgeable outputs for 470 watts RMS total output power
• Toroidal Power Supply
• 2 stereo low-level (RCA) inputs and one high-level (speaker) input, and one
auxiliary low-level output
• Automatic source switching with adjustable delay timer (3-15 seconds)
• Two sets of speaker outputs selectable from the front panel
• Rear mounted L/R main volume controls with front mounted volume and balance
trim controls
• Flexible Power-on: Switched, Signal Sensing, and 12v trigger
• 5 way speaker wire binding posts for bare wire or Banana plugs
Spec
• 150W per channel into 8 ohm loads
with less than 0.2% THD+N
• 235W per channel into 4 ohm loads with less than 0.2% THD+N
• 470W Bridged Mono into 8 ohms with less than 0.2% THD+N
• Crosstalk: >65dB @ 1kHz, ref. to rated power into 8 ohms
• Frequency Response: (20Hz to 20kHz)+0.0dB, -0.5dB
• Signal to Noise ratio: -103dB ref. to rated power into 4 ohms
• AC Power Consumption: 1200W (all channels driven)
• Net Weight: 28.6 lbs (13.0 kgs)
• Gross Weight: 36.5 lbs (16.6 kgs)
« 
