SKU: IWS8
OSD IWS88" 150W Pro Series In-Wall Home Theater Subwoofer, Easy Install & Paintable Grille, Single
Features
- 8" Polypropylene Woofer
- Butyl Rubber Surround for High Performance
- Dog-Leg Mounting System
- Integrated Rear Dust Shield
- Spray Paintable Frame & Grill
In-wall subs are a great way to experience low frequencies effects without filling up floor space. An excellent in-wall subwoofer at an excellent price, the IWS8 is an 8" passive sub with power handling up to 150 Watts. Installation is easy with our dog-ear bracket system that mounts to the sheet-rock after the cut-out hole has been made. The grille is also paintable to match your room decor and we include a cutout template that doubles as a paint shield.
Amplifier Suggestions
OSD Audio in-wall subs are passive devices, meaning they do not include a built-in amplifier like you would find in our active "box" subs. You will have to provide additional power, specifically a subwoofer amplifier, to drive it. We recommend our SMP200 dedicated subwoofer amplifier that features 120 watts (mono) and front panel controls, phase switch, frequency control knob (35 Hz to 160 Hz) and volume control.
Warning: California's Proposition 65
Warning:
This product can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
- Speaker Type: 8" In-Wall Subwoofer
- Woofer: 8" Polypropylene
- Frequency Response: 40Hz - 200Hz +/-3dB
- Power Handling: 150 Watts
- Sensitivity: 2.83V/1m: 87 dB
- Impedance: 8 Ohms
- Inputs: Spring Binding Posts
- Install-friendly Dog Ear Installation Brackets
- Cut-Out Template for Easy Installation
- Paintable Grille & Frame Included
- Integrated Rear Dust Shield
- Sold As: Single
- Mounting Depth (Assuming .5" Drywall): 3.63"
- Unit Dimensions: (L x H x D) 10" x 10" x 3.6"
- Cutout Dimensions: (L x H) 8.75" x 8.75"
- Weight: 6.5 lbs
- Warranty: 10 Years
- *Note: Requires Additional Subwoofer Amplifier
View Owner's Manual
13 Questions asked
Have a Questions?
What's on your mind?
Curtis • 12/17/2019, 2:17:43 PM
What type of wire do you run from the amp to the this sub?
Customer Service • 12/17/2019, 2:17:43 PM
Two conductor (+/-) speaker wire, we would recommend our 14 Gauge 2 conductor CL3 rated in-wall wire as the best choice.
TL
Curtis • 12/17/2019, 2:17:43 PM
What type of wire do you run from the amp to the this sub?
Customer Service • 12/17/2019, 2:17:43 PM
Cutis,
You would run standard speaker cable from the amp to the IWS-8
CL
Jeff • 12/17/2019, 2:17:43 PM
What volume speaker box would I need if I wanted to build a box and mount it within my wall. Or is it not recommended to box these speakers?
Customer Service • 12/17/2019, 2:17:43 PM
Jeff,
Back boxes are great with these speakers. A standard back box would be approximately 18" L x 17 3/4" W x 5" Depth
CL
Jeff • 12/17/2019, 2:17:43 PM
What volume speaker box would I need if I wanted to build a box and mount it within my wall. Or is it not recommended to box these speakers?
Customer Service • 12/17/2019, 2:17:43 PM
maryanng794 is online.
Tim: Hi Mary Ann
Hi Steven:
We are placing an image on both the OS790 and OM-SUB200 that will feature hook-up for the Sub Sat system. The OS790 is Frequency Response of 42Hz to 20kHz and the Sub200 is rated at 50 to 250 Hz. The Sub Sat system allows more focus by the OS790 to produce Frequencies above 250 while the Sub is dedicated to Low Frequenices only. Having a dedicated subwoofer in line with the satellite speakers provides more total ouput especially important for wide open spaces.
Question #639
Sent at 1:47 PM on Monday
Tim: Hi Jeff:
If you are planning to build a box inside the wall versus in-Ceiling the measurements would be closer to 24" tall by 14 1/2" x 4". We would recommend using 1 x 4" for the frame and 1/2" Plywood or MDF walls. It is recommended using Silion chaulk to seal all the seams on the inside. The real benefit for enclosing especially inside the wall is to make sure your bass information comes out into the intended room and not out the backside.
TL
Answer #2 for 646
Sent at 2:03 PM on Monday
Tim: HI Dave:
The Speaker features two hand mounting screws to disconnect the speaker from the Bracket, Then just disconnecting the speaker wire then your done. You have the option of removing the Speaker Brackets if you choose and depending on the screws you select you might not have to take the screws all the way out just loosen them enough to slide the bracket and remove it.
TL
Question 648
Sent at 2:10 PM on Monday
Tim: Hi Alonzo:
You can connect up to two 8 ohm Subwoofers to the M3 (SMP250) Subwoofer Amplifier. That would limit you to two of the IWS8 subs or two of the IWS10 (Bigger woofers more cone area more output) or we even have the IWS88 Dual 8 inch subs that are rated at 8 ohm so connecting two pair of these gets you even more cone space while showing the SMP250 Subwoofer amplifier a 4 ohm load. Creating dedicated sealed enclosures also will help increase output as well.
TL
Q649
Sent at 2:16 PM on Monday
maryanng794: Hi Steven,
We are placing an image on both the OS790 and OM-SUB200 that will feature hookup for the Sub Sat system. The OS790 has a Frequency Response of 42Hz to 20kHz and the Sub200 is rated at 50 to 250 Hz. The Sub Sat system allows more focus by the OS790 to produce frequencies above 250 while the Sub is dedicated to Low Frequencies only. Having a dedicated subwoofer in line with the satellite speakers provides more total output, which is especially important for wide open spaces.
Question #639
Hi Jeff,
If you are planning to build a box inside the wall versus in-ceiling, the measurements would be closer to 24" tall by 14 ?" x 4". We would recommend using 1 x 4" for the frame and 1/2" plywood or MDF walls. We recommend using Silicone caulk to seal all the seams on the inside. The real benefit for enclosing especially inside the wall is to make sure your bass information comes out into the intended room and not out the backside.
TL/MA
Migoni • 12/17/2019, 2:17:43 PM
I bought this Sub with SMP60 Sub-woofer Amp and I am unable to get any good bass out of it. I was expecting to at least get a bit of kick out of it but I have nothing. I have tried all of the settings that I can think of and nothing seems to be helping. Do I need to build an in wall box to improve performance or is there something I can do to quickly improve the sound out of the sub?.
Customer Service • 12/17/2019, 2:17:43 PM
Hi Migoni,
The SMP60 amplifier does not have the power to drive a Dual 8" sub. We group this amp with the single IWS8 only. You need to exchange the SMP60 for the SMP250. Please go to the bottom of our home page under support. The link is: How to Return a Product.
CL/MA 1580