Related Products
The unit lets you switch between two amplifiers and 1 pair of speakers or 2 pairs of speakers and 1 amplifier with just a push of a button. It is compatible with any speaker and/or volume control combination.
Warning: California's Proposition 65

Warning:
This
product can expose you to chemicals including Bisphenol A (BPA) which is known
to the State of California to cause birth defects or other reproductive harm.
For more information go to www.P65Warnings.ca.gov
- 100W Power Handling
- Frequency Response: 20Hz - 20KHz
- Wiring Requirement: 14-16 gauge wire
- Mounting: Fits most standard single-gang junction boxes
- Dimensions: (W x H x D) 1" x 2.75" x 1.75"
- Warranty: 5 Years
27 Questions asked
Have a Questions?
What's on your mind?
Gene Tilley • 12/17/2019, 2:17:43 PM
I have a 110 watt per channel amp and will have two sets of 8 ohm speakers. Total of 4 speakers to run the two stereo zones. Wiring will be 14 gauge copper. Will this switch work?
Customer Service • 12/17/2019, 2:17:43 PM
Hi Gene:
Are you looking for an A and B switch so you will be listening to either Speaker A or Speaker B buy never at the same time? If so then the switch should do the trick. If you are looking for a little more flexibility, you should check out the SSVC2. It will allow you to play either A or B or both at the same time. It also features an Impedance matching Volume Contol for each speaker. It also features Dual input so you can play a different source for each at the same time. Speaker A could be playing Source A, and Speaker B could be playing Source B.
Just a thought
TL/5404
Matt • 12/17/2020, 9:09:44 AM
Who makes this part? It appears to look exactly like the Russound AB-1.2. Is it the same?
Customer Service • 12/18/2020, 12:18:01 PM
Hi Matt:
Based upon the owner's manual the board layouts are slightly different, but they could be out of the same factory.
TL-12-18-2020