The OSD Audio AP650 outdoor patio speaker pair is the perfect choice for enhancing your outdoor audio experience. With an IP54 rating for protection against dust and water, these speakers feature a frequency response of 35Hz to 22kHz +/- 10dB, power handling of 150W, and sensitivity of 90 dB. The gold-plated spring-loaded binding posts ensure a secure connection. The powder-coated rust-resistant aluminum grille, ABS polymer enclosure and full motion bracket make these speakers durable for outdoor use and easy to install in any position. The 6.5-inch water resistant paper cone woofer provides full sound and deep, rich bass. These speakers are perfect for patios, decks and overhangs and are safe from pool chemicals. They are sold as a pair and available in black or white, and comes with a 1-year warranty.
- Mounting bracket is designed to mount either vertically or horizontally
- Available with 70V switch for commercial installations
- Gold-plated spring compression binding posts for optimum connectivity
- Sturdy ABS polymer frame
- Powder-coated rust-resistant aluminum grille
Warning: California's Proposition 65
This product can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.
- Speaker Type: 6.5" Indoor/ Outdoor Patio Speakers, 70V Optional
- IP54 Rated
- Woofer: 6.5" Water Resistant Paper Cone Woofer
- Tweeter: 1" Silk Dome
- Frequency Response: 35Hz to 22kHz +/- 10dB
- Power handling: 150W
- Sensitivity: 90 dB
- Impedance: 8 Ohms w/ Optional 70V Transformer Built-In
- 70V Taps: 32W, 16W, 8W and 4W
- Gold-Plated Spring-Loaded Binding Posts
- Powder-coated Rust-resistant Aluminum Grille
- Full Motion Bracket
- Unit Dimensions: (L x H x D) 11.9" x 7.8" x 7.6"
- Sold As: Pair
- Colors Available: Black / White
- Weight: 9 lbs Each Speaker
- Warranty: 1 year
93 Questions asked
What's on your mind?
Thomas Jennings • 06/14/2021, 2:05:33 PM Are these wireless/bluetooth?
Customer Service • 06/15/2021, 11:47:25 AMHi Thomas: The AP650 is a pair of 6.5" 2-way Passive speakers. They need to be hard-wired. Next, you want to look at the BTP650, which utilizes the same cabinet design. It features one main speaker with an internal Bluetooth receiver and 2 channel stereo amplifier. It needs to be connected to an AC outlet with the external Weather-resistant Power Supply that comes with the kit. The internal speakers in the main speaker are connected to the left channel output of the internal stereo amplifier. The right channel output needs to be connected to the second passive speaker with the speaker wire supplied in the kit. The Bluetooth device connects to the main speaker wirelessly. It can be from your smartphone, tablet, or An Alexa Dot when set up as a Bluetooth transmitter. TimL/6-15-21
Nikhil Chanani • 07/04/2022, 8:58:52 AM Hi there - I am putting together a wired 5.1 Home Theater in our covered patio area (about 15' by 20'). Along with an HTR, I was going to add an active, powered subwoofer. For my front L/R speakers, I was leaning towards the AP650. For the rear surround L/R, would you suggest the AP520/525 or the AP650. Also, do you sell any single center channel speakers that would match or can they only be purchased in pairs? Thanks!
Customer Service • 07/06/2022, 12:08:22 PMI am designing an 8.1.2 outdoor theater system where I recommended a 7.2 DENON Receiver that will do 4-ohms for front left and right, Center channel as well side and rear surrounds. The front stage will be a pair of AP650 for the left and right front speakers. Another pair of AP650 is wired in parallel for the Center channel (4-ohm). A pair of FORZA 4" Pendant Speakers (wall/ceiling mounted) for the height speakers and two pairs of FORZA4" Pendant Speakers for left and right surround front and back (wired in parallel, 4-ohms). I am adding a FORZA10 10" outdoor passive subwoofer powered by an external SMP300 sub amp. The area is long and narrow (7' x 25'). All speakers featured are white except for the Subwoofer. You typically want to use all the same speakers for the front channels and the exact size driver or slightly smaller for the surrounds and effects speakers. I just wanted to let you know that you never mentioned which speakers you used for the front stage. TimL/7-6-2022 [email protected]
Jonathan • 03/20/2023, 9:39:10 PM Wanting to upgrade to these from the ap525’s. The brackets have rusted and the screw knobs to hold the speaker to the bracket have completely rusted out. These would be in direct expose to the elements. I’m guessing the ap650’s come with the same kind of hardware that does not weather well. Another model I had in mind is the p83 mkll. Is the p83 mkll model made of different material for direct expose that will not rust such as brass screw knobs, or stainless steel hardware?
Customer Service • 03/22/2023, 1:50:20 PMHi Jonathan: The mounting brackets on the AP525, AP650, and AP850 are all the same design, Waterproof Powder Coated C Brackets. The mounting block is not metallic. The screw inserts on the speaker itself are brass. You can weatherize the screws by applying weatherproof Silicon. All feature rustproof Aluminum Grills. The new P83 MKII has similar hardware to the three mentioned above. TimL/3-23