ACE670 6.5" Angled LCR Trimless In-Ceiling Speaker, 90W, 1" Pivoting Tweeter, Paintable Magnetic Grill, White

The OSD Audio ACE670 is a 6.5" angled LCR (left, center, right) trimless in-ceiling speaker that keeps the imaging and staging regular down-firing ceiling speakers lose. Its woofer is fixed at a 15-degree angle to aim sound toward the listening area, and a pivoting tweeter gives you even more control over placement.

• ANGLED FOR BETTER IMAGING: The 6.5" woofer is fixed at a 15-degree angle to aim sound at your seats, keeping imaging that down-firing ceiling speakers lose. Angled design suits overhead channels in immersive surround formats such as Dolby Atmos®.
• PIVOTING TWEETER: The 1" pivoting aluminum dome tweeter fine-tunes where the highs go, so dialog and effects stay clear from overhead. Carbon fiber composite woofer, 45Hz - 20kHz, 89 dB sensitivity, 90W handling.
• TUNE IT TO THE ROOM: A front-mounted contour switch lets you tailor the bass and treble to the room and your taste after the speaker is installed - no need to pull it back out of the ceiling.
• BUILT TO LAST: A butyl rubber surround gives deeper bass and wider frequency response, and lasts about twice as long as foam - roughly 25 years versus 12 to 15. Gold-plated 5-way binding posts keep connections secure.
• TRIMLESS AND EASY TO INSTALL: A spray-paintable magnetic micro-flange grill sits flush to the ceiling, and built-in dog-ear brackets lock in from the front. 8.12" cutout, 8.76" diameter, 4.5" depth. Sold as a single speaker.
• WARRANTY: Backed by OSD Audio's 10-year warranty.

Use the ACE670 for front left, center and right channels where wall speakers will not work, or as front, rear and side surrounds in a 5.1 or 7.2 home theater. Angled design suits overhead channels in immersive surround formats such as Dolby Atmos®. Because the sound is aimed, you can mount the speakers where the ceiling allows and still get focused sound at the seats.

Inside, a sturdy 6.5" carbon fiber composite woofer pairs with a 1" pivoting aluminum dome tweeter. Frequency response is 45Hz - 20kHz, sensitivity is 89 dB and power handling is rated at 90W. A front-mounted contour switch lets you tailor the bass and treble to the room after installation.

The woofer uses a butyl rubber surround, which gives deeper bass and a wider frequency response than foam and lasts about twice as long - roughly 25 years compared with 12 to 15. Gold-plated 5-way binding posts give a secure connection to any 8-ohm amplifier or AV receiver.

The trimless Architectural Ceiling Element (ACE) design is flush mounted and hardly noticeable. The micro-flange grill is held on by strong magnets and is spray paintable to match the ceiling. Built-in dog-ear brackets make installation quick: cut an 8.12" hole, wire the speaker, set it in place and tighten the front screws. The speaker measures 8.76" in diameter with 4.5" of mounting depth.

Sold as a single speaker with a spray-paintable magnetic grill. Passive - an amplifier or receiver is required. Backed by OSD Audio's 10-year warranty.

Dolby and Dolby Atmos are registered trademarks of Dolby Laboratories.

FAQ

Do I need an amplifier?

Yes. The ACE670 is a passive 8-ohm speaker. Connect it to any stereo amplifier, AV receiver or multi-zone system that drives 8-ohm speakers.

What size hole do I cut?

Cut a 8.12" hole. The speaker measures 8.76" x 4.5" (diameter x mounting depth).

Can I paint the grill?

Yes. The white magnetic grill is spray paintable to match your ceiling.

Warning: California's Proposition 65

Warning:  

This product can expose you to chemicals, including vinyl chloride, which is known to the State of California to cause cancer. For more information, go to www.P65Warnings.ca.gov.

Reviews for Outdoor Speaker Depot are collected and verified by Shopper Approved. Read our verified customer reviews.

Bought this? Shopper Approved will email you a link to review it after your purchase.

• < Previous
• 1
• 2
• 3
• 4
• 5
• Next >